Home | Ask Your Question | Mortgage Glossary
Find me a lender for:  
Eliminating that Terrible Hum From Your Home Theater Speakers By Steve Faber

You've all heard it, that dreaded 60Hz hum through the speakers of a home theater or house audio system. Hopefully you heard it at a friend's house and not your own. It can drive you completely nuts. You may have even tried, unsuccessfully, to fix the little noise problem. That can make you even more crazy. What causes that horrendous noise through your speakers?

More often than not humming through your speakers is caused by a grounding problem. There are three main ground problems that cause problems in an audio / video system. These are ground loops, improper grounding and lack of a ground altogether. The other possible culprits that can cause noise are bad cables, a faulty piece of equipment or electrical noise from a lighting dimmer or electric motor. There are steps you can take to troubleshoot the noise and eliminate it from you theater.

The first step is find out where it is coming from. Disconnect your source and display equipment from your receiver or surround sound processor. If the noise stops, connect them back to the receiver or processor on at a time until the noise returns. When the hum comes back, you found where the noise is entering your system. Note that if you are connecting remote equipment, such as running the signal from your theater room DVD player to the TV in the bedroom, your chances to pick up noise increase dramatically. With such long runs, noise can be induced into the long cable runs from adjacent electrical wiring. It is also easy to create a ground loop, because the equipment is plugged into two different, widely separated outlets, on different electrical circuits.

If the noise is caused by a cable box, the noise is likely caused by the cable TV ground. To test this theory, disconnect the incoming cable TV feed to the rear of the cable box or TV while they are still connected to the rest of the system. If the noise is eliminated by disconnecting the TV cable, the problem is the cable TV ground. You can electrically decouple the cable TV feed from your system with a ground breaking transformer. These are available from many sources. Be advised that many newer, digital cable TV systems require any device in the signal chain to pass a full 1,000 Mhz. Some of the older ground break transformers will not do this. Be sure to check the specifications of whatever device you are purchasing to verify it will pass the digital cable TV signal.

If the noise is from your projector, TV, or monitor, it is most likely caused because the video display device is plugged into a different outlet than the other a/v equipment. It could be on a different circuit as well. These circuits may have two different ground potentials. That is, the resistance to ground is different on each circuit. A difference in resistance to ground from one ground point to another can cause the dreaded ground loop. If you get a ground loop, current flows between the two components. If the current flows through the components internal audio signal ground, you will get a hum.

You can use an isolation transformer, similar to the type used for cable TV ground problems, to eliminate the electrical connection from one component to the other. These transformers are inserted in line with the audio signal connection between the two components. If there is no audio connection between the components, the problem may be current flowing through the video portion. In this case, a video isolation transformer should be used to eliminate the ground loop.

Sometimes power conditioners will stop noise problems by placing equipment on different, electrically isolated outlets. This is done using isolation transformers. Sometimes this is ineffective however, due to the differences in internal construction of different power conditioning equipment. Some safety regulations, such as UL 1950, specify that an isolation transformer is only allowed to isolate the hot and neutral wires; the grounding wire must be passed straight through. If this is the case, the ground loop problem may still exist because many communication circuits are connected to the grounding conductor and not the neutral. In this case, the isolation transformer, or any power conditioner or UPS with an isolation transformer will have absolutely no affect on the grounding problem.

The noise may be generated externally, from a dimmer or refrigerator compressor for example, and coming in through the main power input on the audio video equipment. In this case, a high quality power conditioner may be effective in reducing or eliminating the noise problem. You may also find that one of the signal interconnecting cables in your system is faulty. This can also cause noise problems. Check for this by swapping the cables with one that you know to be good.

You can solve most noise problems in your home theater or multi room audio/video system by taking the systematic, step-by-step approach. Work your way up the signal chain, eliminating each piece of equipment as you go. If you have nothing connected to your speakers except the speaker wiring, and they still hum, the problem is noise induced into the speaker wiring from adjacent power cables. Other than that case, most problems are caused by ground problems, which you can find, and solve, if you take it one step at a time.

Steve has 15 yrs in the consumer electronics industry. He is a CEDIA certified designer with ISF and THX certificates. His experience includes: installer and programmer; system designer; business unit director for an a/v importer; sales rep for a CE distributor; and principal of a $1.5M+ CEDIA firm. He's now senior sales engineer for Digital Cinema Design in Redmond, WA. For more information on how to make your home theater better, and what's on the horizon, including CEDIA and CES show reports, see The Home Theater and Automation Guide





See Also:

White House Tennessee Real Estate
White House Tennessee Real Estate White House, Tennessee, is located in Robertson County, of , and 23 miles N of Nashville, Tennessee. White House has a population of 7,220. White House Homes White House properties pool is 2,514 residential properties including White House new homes. ... more...

House Sitters Love Their Life
There does not seem to be a lack of home owners who seek out the services of a house sitter. Our modern age has drastically changed the lifestyle of many. With business travel, military assignments and even some families owning more than one home, house sitters never have to fear being without a ... more...

17 Sure Fire Tips for a Successful Open House
The Sunday open house is a longstanding ritual in the real estate market, and many a home has been sold on a lazy Sunday afternoon. When used properly, the Sunday open house can be a great marketing tool.The following steps will help you get the most out of your open house and increase your ... more...

House Sitters Are Coming to the Rescue of Many Travellers
Everyone seems to have accepted the fact that the days of leaving your door unlocked are over. The rise of crime is affecting everyone, not just those who live in the larger cities. In fact, homes in rural areas are being targeted like never before--due to the opportunity a secluded area provides ... more...


More on house...

Search More Info On:

  • Home Electric
  • Find House
  • Home Wiring
  • First House
  • First Home
  • Mp3 Player
  •  

    Shop For Your Mortgage Now!
    Shop For Your Mortgage Now!

    You'll be re-directed to Top-Lenders.com

    Want to Know Your Rate?
    Get Customized Mortgage Quote Instantly

     
    ExplainingMortgages © 2005 - 2009